Micro Hair Extensions Guide: Prevent Bead Loss & Extend Lifespan

We understand that bead loss is a common concern for users of our Pre Bonded Micro Hair Extensions—nothing is more frustrating than dealing with loose beads after installation! The good news is that most bead shedding issues stem from improper installation techniques or inadequate daily care, not product quality. This comprehensive guide is designed to walk you through every key step, from pre-installation preparation to daily maintenance, with clear instructions and visual references.

1.Preparations before installation

Prepare items	effect
Miniature bead pressers	Even force distribution prevents beads from deforming or not being pressed firmly.
Silicone anti-slip microbeads	Increase friction with hair strands and reduce slippage.
Tip comb	Precisely separate the hair strands to avoid stray hairs interfering with fixation.
Alcohol swabs	Cleanses hair of oil and dirt, and improves the adhesion of beads.

2.Correct installation process

Step 1: Cleanse hair and section it for cleaning.

Wipe the hair at the desired placement location with an alcohol swab (1-2cm from the roots). After the alcohol evaporates, use a rat-tail comb to part the hair into horizontal sections 1-1.5cm wide from behind the ear towards the top of the head.

The hair must be dry and free of oil! If the strands are too thick, the beads won’t hold together properly; if they’re too thin, they’ll easily slip off.

Step 2: Thread beads and hang the hair, then adjust the position.

Use pliers to open the microbeads, then place the bead onto the teeth of a pointed comb. Following the comb teeth, thread the sectioned hair through the microbead, then pull the microbead to a distance of 1.5-2cm from the roots.

The beads should be oriented correctly (the inner anti-slip ring should face the hairline) to avoid reverse installation, which would cause the anti-slip mechanism to fail.

Step 3: Press the beads to fix them

Pinch the microbead between your left thumb and forefinger to hold it in place without wobbling

Hold the special bead-pressing pliers in your right hand, align the pliers with the center of the microbead, and gently close the jaws. Press lightly once to position it

Then press with moderate pressure twice more (once on each side) to ensure the bead is completely deformed and conforms to the hair strand without damaging it.

The pressure should be just right! Too light and the beads will loosen; too heavy and they will break the hair or damage the beads. After pressing, the beads should be “flat ovals,” not “flat and collapsed.”

Step 4: Check the firmness

After installation, gently pull the end of the hair tie. If the beads do not slip and no hair strands fall out, it is considered qualified. If the beads can rotate, they need to be re-pressed.

Following the steps above, install the bundles sequentially along the designated zones, spacing each bundle 1-1.5cm apart, avoiding concentration in the same area.

3.Precautions during wearing

Gently comb your hair from the ends towards the roots, avoiding the area around the beads.

Wash gently, lathering the shampoo before applying it to the hair, avoiding direct rubbing of the beads; after washing, gently pat dry with a towel, do not wring.

First, use a low heat setting to dry the roots, then dry the ends. Hold the hairdryer at least 15cm away from the beads, and do not blow directly onto the beads.

You can tie your hair in a loose low ponytail or wear a sleeping cap when you sleep.

We also welcome you to share your successful installation experiences or small tips in the comment section below—let’s help each other enjoy beautiful, hassle-free hair extensions! Thank you for choosing our products, and we look forward to accompanying you through every moment with gorgeous, secure hair.

Sunny Beauty

Need help for extensions?

We are here for you!

If you need any help for hair extensions, please feel free to contact us anytime. Our dedicated after-sales team is ready to provide you with the best service! 😊

Collect this post: